Using The Smart Speed Tm Control System; Using The Side Discharge - Toro TimeCutter HD MyRide Operator's Manual

Using the Smart Speed
Control System
The Smart Speed TM Control-System lever, located to
the right of the operating position
you a choice to drive the machine at 3 ground speed
ranges—trim, tow, and mow.
Figure 26
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and
outward to the N
EUTRAL
2. Disengage the blade-control switch.
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments vary by grass type, moisture content,
and the height of the grass.
Suggested Trim
uses:
Parking X
Heavy, wet X
grass
Training X
Bagging
Mulching
Normal
mowing
Moving the
machine
Trim
This is the lowest speed. The suggested uses for this
speed are as follows:
•
Parking
•
Heavy, wet grass mowing conditions
•
Training
TM
(Figure 26), gives
g197125
-L position.
OCK
Tow Mow
X
X
X
X
Tow
This is the medium speed. The suggested uses for
this speed are as follows:
•
Bagging
•
Mulching
Mow
This is the fastest speed. The suggested uses for this
speed are as follows:
•
Normal mowing
•
Moving the machine

Using the Side Discharge

The mower has a hinged grass deflector that
disperses clippings to the side and down toward the
turf.
DANGER
Without a grass deflector, discharge cover, or
a complete grass-catcher assembly mounted
in place, you and others are exposed to blade
contact and thrown debris. Contact with
rotating mower blade(s) and thrown debris
will cause injury or death.
• Never remove the grass deflector from the
mower deck because the grass deflector
routes material down toward the turf. If the
grass deflector is ever damaged, replace it
immediately.
• Never put your hands or feet under the
mower deck.
• Never try to clear the discharge area
or mower blades unless you move the
blade-control switch (PTO) to the O
position, rotate the key switch to the O
position, and remove the key from the key
switch.
• Make sure that the grass deflector is in the
down position.
24
FF
FF