Servicing The Fuses - Toro TimeCutter HD MyRide Operator's Manual

Figure 46
1. Positive (+) battery post
2. Negative (–) battery post
Installing the Battery
1. Position the battery in the tray
2. Using the fasteners previously removed, install
the positive (red) battery cable to the positive
(+) battery terminal.
3. Using the fasteners previously removed, install
the negative battery cable to the negative (-)
battery terminal.
4. Slide the red terminal boot onto the positive
(red) battery post.
5. Secure the battery with the hold-down
45).
6. Install the battery cover by pushing down and
tightening the 2 fasteners clockwise
g000538
3. Red (+) charger lead
4. Black (–) charger lead
(Figure 45).
(Figure
(Figure 44).

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse type:
•
Main—F1 (15 A, blade-type)
•
Charge Circuit—F2 (25 A, blade-type)
To replace the Main (15 A) fuse, reach into the
opening in the side of the console, pull out the fuse,
and install a new 15 A fuse
1. Main (15 A)
To replace the Charge Circuit (25 A) fuse, locate the
fuse to the left of battery, pull out the fuse, and install
a new 25 A fuse (Figure
1. Charge circuit (25 A)
39
(Figure 47).
Figure 47
2. Console opening
48).
Figure 48
g190588
g190589