After Operation; After Operation Safety; Pushing The Machine By Hand - Toro TimeCutter HD MyRide Operator's Manual

After Operation

After Operation Safety

General Safety
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
Shut off the fuel before storing or transporting the
machine.
•
Disengage the drive to the attachment whenever
you are transporting or not using the machine.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Pushing the Machine by
Hand
Important:
Always push the machine by hand. Do
not tow the machine, because damage may occur.
This machine has an electric-brake mechanism, and
to push the machine, the ignition key must be in the
position. The battery needs to be charged and
RUN
functioning for the electric brake to be disengaged.
Pushing the Machine
1. Park the machine on a level surface, and
disengage the blade-control switch.
2. Engage the parking brake, shut off the engine,
and wait for all moving parts to stop before
leaving the operating position.
3. Locate the bypass levers on the frame on both
sides of the engine.
4. Move the bypass levers forward through the key
hole and down to lock them in place
Note:
Do this for each lever.
5. Disengage the parking brake.
Note:
Do not start the machine.
1. Bypass lever
2. Lever position for
operating the machine
6. When finished, engage the parking brake.
(Figure 30).
28
Figure 30
3. Lever position for pushing
the machine
g298692