Table of Contents
Advertisement
3.8 PnP/PCI Configuration
Both the ISA and PCI buses on the CPU card use system IRQs & DMAs. You must set
up the IRQ and DMA assignments correctly through the PnP/PCI Configuration Setup
utility, otherwise the motherboard will not work properly.
PnP/PCI Configuration Setup Screen
CMOS Setup Utility – Copyright © 1984-2001 Award Software
PnP OS Installed
Reset Configuration Data
Resources Controlled By
IRQ Resources
DMA Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
á â à Move Enter: Select
F5: Previous Values F6: Fail-Safe Defaults
PnP OS Installed : When set to "Yes", BIOS will only initialize the PnP cards used for
booting (VGA, IDE, SCSI). The rest of the cards will be initialized by the PnP operating
system like Windows® 95 or 98. When set to "No", BIOS will initialize all the PnP cards.
So, for non-PnP operating system (DOS, Netware®), this option must set to "Yes".
Reset Configuration Data : Normally, you leave this field "Disabled", Select "Enabled" to
reset Extended System Configuration Data (ESCD) when you exit Setup if you have
installed a new add-on and the system reconfiguration has caused such a serious conflict
that the operating system cannot boot.
The settings are : "Enabled and Disabled".
PnP/PCI Configurations
No
Disabled
Manual
Press Enter
Press Enter
Disabled
Enabled
Enabled
+/-/PU/PD: Value
F10: Save Esc: Exit
~ 39 ~
AWARD BIOS SETUP
Item Help
Menu Level
Select Yes if you are
using a Plug and Play
capable operating
system. Select No if you
need the BIOS to
configure non-boot
devices.
F1: General Help
F7: Optimized Defaults
Advertisement
Table of Contents
