Table of Contents
Advertisement
JUMPER SETTING AND CONNECTORS
2.3 I
NSTALLING THE
A DIMM module simply snaps into a socket on the system board. Pin1 of the DIMM
module must correspond with Pin1 of the socket.
Tab
Pin1
1. Pull the "tabs" which are at the ends of the socket to the side.
2. Position the DIMM above the socket with the "notches" in the module aligned with the
"keys" on the socket.
3. Seat the module vertically into the socket. Make sure it is completely seated. The tabs
will hold the DIMM in place.
2.4 J
S
UMPER
In order to select the operation modes of your system, configure and set the jumpers on
your SBC to match the needs of your applications. To set a jumper, a plastic cap
containing metal contacts is placed over the jumper pins as designated by the required
configuration as listed in this section. A jumper is said to be " on " or " 1-2 " when the
cap has been placed on two of its pins, as show in the figure below:
A pair of needle-nose pliers is recommended when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact our local
sales representative before you make any changes. In general, you simply need a
standard cable to make most connections
DIMM M
Notch
Key
O
ETTING
VERVIEW
:
ODULE
~ 6 ~
Tab
Advertisement
Table of Contents
