Table of Contents
Advertisement
4.
5. HIGH FLOW LIGHT FLASHES
This indicates the shower is commissioning.
Water flows for approximately 1 minute 20 seconds.
In some cases the cycle can take up to 3 minutes.
Allow the shower to stop automatically.
IMPORTANT! DO NOT INTERRUPT THE CYCLE!
FLOW LIGHT doesn't flash... solution ...Restart the commissioning cycle as
step one.
6. Push START/STOP to turn the
shower ON.
C h e c k t h a t t h e m a x i m u m
temperature is acceptable to the
user.
7. Push START/STOP to turn the
shower OFF.
Wait until the water has stopped
flowing BEFORE turning the Power/
Electric OFF.
8. Residual water may drain over a few
minutes.
BEAB Care
If the shower's maximum temperature is set to 41 °C or cooler, there is a clear triple
beep tone and single pulse of the Start/Stop light every time the double pole switch
is turned on. This is to indicate that the appliance is in a 'BEAB Care' compliant
mode. If recommissioning is required whilst in this mode, wait until beeps have
passed before starting the commissioning cycle.
When set in 'BEAB' mode, the maximum set temperature is reached when the
temperature control is turned to number '9'.
1st Beep (LONG) - Release START/STOP.
2nd Beep (SHORT) - Release FLOW.
x3
18
+
_
OFF
Advertisement
Table of Contents
