Before Washing For The First Time; Transportation - Bosch WDU28 Series Instruction Manual

Table of Contents

Advertisement

Positioning and connecting
en
The appliance is only connected to
an alternating current via a properly
installed earthed socket.
The mains plug fits the socket.
The earthing system is properly
installed.
The mains cable is only replaced by
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
extension cables are used.
If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
all times.
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Û Limp. tambor (Drum Clean)
programme the first time without
laundry.
Note:
The appliance must have been
installed and connected properly.
~ "Positioning and connecting"
on page 13
Never switch on a damaged
appliance.
20
Insert mains plug.
1.
Turn the water tap on.
2.
Press the # button till the indicator
3.
lamp lights up, release the button.
The appliance is switched on.
Close the door. Do not load any
4.
laundry.
Select the Û Limp. tambor (Drum
5.
Clean) 90°C programme.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
7.
dispenser II.
Add standard detergent to
8.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent over sudsing, use
Note:
only half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
9.
Select A.
10.
When the programme ends, press
11.
the # button till the indicator lamp
turns off, release the button.
Your appliance is now ready for use.

Transportation

e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose. ~ Page 44
Drain any residual water.
3.
~ Page 42
Disconnect the appliance from the
4.
mains.
Remove the hoses.
5.
Empty the dispensers.
6.
~ "Detergent drawer and housing"
on page 42

Advertisement

Table of Contents
loading

Table of Contents