Table of Contents
Advertisement
Faults and what to do about them
en
Faults
The spin result is not sat-
isfactory.
Laundry wet/too damp.
The spin cycle runs sev-
eral times.
Residual water in the dis-
penser for care product.
Compartment M is not
rinsed out completely.
The programme is taking
longer than usual.
The length of the pro-
gramme changes during
the wash/dry cycle.
Foam may come out of
the detergent drawer.
Odours, stain formation in
the appliance.
Loud noises, vibrations
and appliance "move-
ment" during the spin
cycle.
The Touch-Display indica-
tor lights do not work
while the appliance is run-
ning.
48
Cause/Remedy
Not a fault – the unbalanced load detection system has interrupted the
■
spin cycle because the laundry is unevenly distributed. Distribute small and
large items of laundry evenly in the drum.
Is p (Easy iron) additional programme setting selected (depending on
■
the model)?
Is Á (Silent) additional programme setting or Silent programme selected
■
(depending on the model)?
Is the selected spin speed too low?
■
Not a fault – the unbalanced load detection system is adjusting an imbalance.
Not a fault – effect of the care product not impaired.
■
If required, remove the insert. Clean the detergent drawer and re-insert it.
■
Remove the insert. Clean the detergent drawer and reinsert it.
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system is activated – a rinse cycle has
■
been switched on.
Not a fault – the programme sequence is optimised for the specific washing/
drying process. This may change the length of the programme shown on the
Touch-Display.
Too much detergent used?
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
dispenser II. (Not for outdoor, sports and down-filled textiles!)
Reduce detergent dosage for the next wash cycle.
Use commercially available low foam detergent and care product which are
suitable for machine.
Run the Û Limp. tambor (Drum Clean) 90°C programme without laundry.
Add washing powder or a detergent containing bleach.
Note:
To prevent foaming, only use half the amount of detergent recommend-
ed by the detergent manufacturer. Do not use detergents designed for woollens
or delicates.
Is the appliance aligned?
■
~ "Alignment" on page 19
Are the appliance's feet fixed? Secure the appliance's feet.
■
Have the transport locks been removed?
■
~ "Removing the transport locks" on page 15
Has there been a power failure?
■
Circuit breaker fuses blown? Reset/replace the fuses.
■
If the fault occurs repeatedly, call customer services.
■
Advertisement
Table of Contents
