Positioning and connecting
en
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Û Drum Clean programme the first
time without laundry.
Note:
The appliance must have been
■
installed and connected properly.
~ "Positioning and connecting"
on page 13
Never switch on a damaged
■
appliance.
Insert mains plug.
1.
Turn the water tap on.
2.
Press the # button till the indicator
3.
lamp lights up, release the button.
The appliance is switched on.
Close the door. Do not load any
4.
laundry.
Select the Û Drum Clean 90°C
5.
programme.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
7.
dispenser II.
Add standard detergent to
8.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent over sudsing, use
Note:
only half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
9.
Select A.
10.
When the programme ends, press
11.
the # button till the indicator lamp
turns off, release the button.
Your appliance is now ready for use.
20
Transportation
e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose. ~ Page 43
Drain any residual water.
3.
~ Page 42
Disconnect the appliance from the
4.
mains.
Remove the hoses.
5.
Empty the dispensers.
6.
~ "Detergent drawer and housing"
on page 41
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if
Note:
necessary.