Tighten the lock nut against the
3.
housing.
In doing so, hold the foot tight and
do not adjust its height.
The lock nuts on all four appliance
feet must be screwed tightly against
the housing.
Electrical connection
:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Never touch or hold the mains plug
■
with wet hands.
Only pull out the mains cable by the
■
plug and never by the cable, as this
could damage it.
Observe the following information and
ensure that:
Notes
The mains voltage and voltage
■
indicated on the appliance (rating
plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
Positioning and connecting
The appliance is only connected to
■
an alternating current via a properly
installed earthed socket.
The mains plug fits the socket.
■
The earthing system is properly
■
installed.
The mains cable is only replaced by
■
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
■
extension cables are used.
If an earth-leakage circuit breaker is
■
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
■
all times.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum Clean Û programme the first
time without laundry.
Note:
The appliance must have been
■
installed and connected properly.
~ "Positioning and connecting"
on page 13
Never switch on a damaged
■
appliance.
Insert mains plug.
1.
Turn the water tap on.
2.
Close the door. Do not load any
3.
laundry.
Select the Drum Clean Û 90°C
4.
programme.
Open the detergent drawer.
5.
en
19