Install And Submerge The Cleaner - Polaris 7000 Owner's Manual

• Always make sure the cleaner head is fully submerged before you begin
operation.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a permanent basis.
• At the end of each cycle, remove the cleaner from the pool.
• Start at the cleaner head and untangle any coils in the cable before storing
the cleaner.
The Polaris robotic cleaner includes a safety feature that automatically stops the
cleaner if it is powered on but not submerged in water. For pools equipped with
a beach area, this safety feature is programmed to drive the cleaner in reverse
and back into the pool when the impeller is out of the water.

Install and Submerge the Cleaner

1. With the control box plugged into a GFCI outlet, spread the floating cable
across the pool deck until you reach the middle of the pool length.
2. Submerge cleaner vertically (1) and hold it under the surface, moving
gently from side to side (2) until the bubbles stop to remove any air trapped
inside (Figure 5).
3. When the bubbles stop, allow the cleaner to sink to the bottom of the pool.
4. Verify the cleaner is sitting on the bottom of the pool. Remove additional
air if the cleaner is still floating.
1
Figure 5. Submerge and Remove Trapped Air
NOTE: For optimal patterning and reduced tangling, the floating cable should enter the
water at the recommended entry point (see Figure 6).
IMPORTANT
2
Page 9