ROOMS TO GO 18564903 Set Up And Operation Manual
  1. Manuals
  2. Brands
  3. ROOMS TO GO Manuals
  4. Indoor Furnishing
  5. 18564903
  6. Set up and operation manual

ROOMS TO GO 18564903 Set Up And Operation Manual

Pwr recl lift chair
Hide thumbs

Advertisement

Table of Contents

SETUP AND OPERATION GUIDE
PWR RECL LIFT CHAIR
SKU: 18564903/ 18564915
Vendor Code: MVLC

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 18564903 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for ROOMS TO GO 18564903

Summary of Contents for ROOMS TO GO 18564903

  • Page 1 SETUP AND OPERATION GUIDE PWR RECL LIFT CHAIR SKU: 18564903/ 18564915 Vendor Code: MVLC...

  • Page 2: Table Of Contents

    TABLE OF CONTENTS Important Safety Instructions Assembly of Your Lift Chair or Recliner Chair Assembly Cord and Transformer Connections Operating Your Single Motor Lift Chair Installation of Back-up Batteries Troubleshooting Note: When placing the furniture on non-carpeted flooring, it is recommended to use some type of floor protection such as an area rug or furniture pads under the chair glides.

  • Page 3: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING. WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons: DANGER: To reduce the risk of electric shock-Always unplug this furnishing from the electrical outlet before cleaning. Unplug from outlet before putting on or taking off parts. Close supervision is necessary when used by or near children, or disabled people.

  • Page 4: Chair Assembly

    CHAIR ASSEMBLY ATTACHING THE CHAIR BACK TO THE CHAIR BASE Figure A Figure C Back Receivers Steel Mechanism Lumbar Post Headrest Figure B Screwdriver required (not included) CAUTION: PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING ASSEMBLY PROCESS. IT IS RECOMMENDED TO USE TWO PEOPLE WHEN ASSEMBLING AND REMOVING THE INSIDE BACKS TO AND FROM THE BASE OF THE FURNITURE.

  • Page 5: Cord And Transformer Connections

    CORD AND TRANSFORMER CONNECTIONS Once the box has been removed from around the chair, you’ll notice the back is laying on top of the seat. There are a couple items to remove from the seat portion of the chair first. Follow the steps below: Remove the zip tie holding the foam bag with the Power Transformer and its cord on the left.

  • Page 6: Operating Your Single Motor Lift Chair

    OPERATING YOUR SINGLE MOTOR LIFT CHAIR Lifts Chair Reclines Chair Page 5...

  • Page 7: Installation Of Back-Up Batteries

    INSTALLATION OF BACK-UP BATTERIES 2 - 9 Volt back-up batteries will lift the chair from the reclined position to the seating position one cycle in case of a power failure. If a power failure occurs and the chair is cycled, the 2 - 9 Volts batteries will need to be replaced.
  • Page 8 Customer Service If you have any questions regarding the use of this unit,or find that your unit needs service, please contact your retailer. • NOTE: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, by the party responsible for compliance could void user's authority to operate the equipment.

This manual is also suitable for:

18564915

Table of Contents