Roland V-Drums TD-6KX Owner's Manual page 13

Replacing the Head
When the Head Should Be Replaced
The head is an expendable item that eventually will wear out
and need to be replaced.
Replacement heads (optional): MH-8 Mesh Head
1. Remove all tuning bolts and washers.
* Press the lock bushing (in figure below) in place with your
finger as you remove each tuning bolt, to prevent the bushings
from being pulled off the frame.
fig.PD-85-Head3.e
Loosen
Hoop's
Rubber Portion
Washer
* The lock bushings prevent rotation and loosening of the tuning
bolts caused by vibrations that are transmitted from the hoop as
you play.
2. Remove the hoop.
3. Remove the old head.
4. Place the new head on the frame.
5. Place the hoop onto the head.
6. Pass the tuning bolts through the washers,
then attach them to the hoop and frame.
7. Next, adjust the tension of the head (p. 11).
* Do not firmly tighten a single tuning bolt by itself.
Tighten
Tuning Key
Tuning Bolt
Hoop
Lock Bushing
Frame
If a lock bushing happens to become separated from the
frame while the head is being replaced, position the
bushing so its four slots are aligned with the
corresponding ridges in the frame, then press down
firmly on the bushing.
fig.LockBush.e
Specifications
PD-85 (V-Pad)
Pad size: 8 inches
Triggers: 2 (Head, Rim)
Dimensions: 245 (W) x 310 (D) x 95 (H) mm
9-11/16 (W) x 12-1/4 (D) x 3-3/4 (H) inches
Weight: 1.7 kg
3 lbs 12 oz
Option: Mesh Head (MH-8)
962a
* In the interest of product improvement, the specifications and/
or appearance of this unit are subject to change without prior
notice.
* Rim triggering is not supported on PD-85 when connected to
any of the tom inputs on the TD-6V Percussion Sound
Module.
USING THE UNIT SAFELY
Lock Bushing
Frame
13