Programme Sequence Display; End Of A Programme; Switching Off - Miele PFD 400 Operating Instructions Manual

en - Operation
Universal
Start at

12:30

This activates the timer.
Changing the timer
If you want to change the time set for the

timer, first press the  button to return to
the programme view.
Tap the  symbol. You can then enter a

new start or finish time.
Deleting the timer
Press the Start/Stop button.

Start programme
immediately
You can either delete the timer setting (
lete timer ) or delete the timer and start the
programme immediately (
immediately
).
Alternatively, you can tap the  symbol
again in the programme view and delete the
timer via the settings that follow.

Programme sequence display

Once a programme has started, the display
shows the programme name, the name of
the current wash phase and the time left un-
til the programme is finished.
Universal
Pre-wash 1

Time left

42
Delete timer
De-
Start programme
1:14
h
Programme parameters such as the actual
and target temperature can be queried dur-
ing a programme sequence.
Tap the  symbol.


End of a programme

After a programme has ended normally, the
LED of the Start/Stop button will go out and
the following will appear on the display.

In addition to this, a buzzer will sound for
approx. 3 seconds (factory default setting).
The buzzer is repeated three times every
30 seconds. To change buzzer settings, see
"Volume".
Tap to acknowledge the display.

If system messages are present, they are
displayed afterwards, e.g. if the salt con-
tainer level or the level of the liquid process
chemicals containers was low during the
programme, or when the next service is
due. Every message needs to be acknow-
ledged individually by pressing OK.

Switching off

Press the  button until the display turns

off.