Changing The Pedal Mode Settings - Boss Drive Zone OD-20 Owner's Manual

Changing the Pedal Mode Settings

Use the following procedure when changing the Pedal mode settings.
* The pedal mode setting is stored in memory when the power is switched off.
1. Disconnect the connection plug from the INPUT jack to switch off the power.
2. While holding down the MEMORY SELECT button, insert the connection plug
into the INPUT jack to switch on the power.
When you release the button, the MANUAL and MEMORY indicators light.
At the same time, the Memory number indicator corresponding to the settings of
the current pedal mode blinks.
3. Set the pedal mode (1–3) pressing the MEMORY SELECT button.
Pedal mode 1: MEMORY 1 indicator blinks.
Pedal mode 2: MEMORY 2 indicator blinks.
Pedal mode 3: MEMORY 3 indicator blinks.
4. Press the WRITE button.
After the MEMORY Number indicator begins blinking rapidly, the setting is stored
in memory and the unit returns to its ordinary state.
* To cancel the setting change, operate the EFFECT ON/OFF pedal or the MANUAL/
MEMORY pedal before pressing the MEMORY WRITE button. The unit will return to
its ordinary state.
Pedal EFFECT ON/OFF
Mode Pedal
1
2
3
EFFECT ON/OFF Pedal
MANUAL/MEMORY Pedal
effect on/off
effect on/off
effect on/off Selects from MEMORY 1–4 Switches MANUAL/MEMORY
MANUAL/MEMORY Pedal
+
Switches
–
MANUAL/MEMORY 1/2/3/4
– Switches MANUAL/MEMORY
Operation
7