Advertisement
Protection cap
Clothing clip for d:fine
TM
TM
The d:fine
Omnidirectional and d:fine
tional, d:fine
Directional microphones come with a red plas-
and d:fine
tic cap which serves to protect the microphone
The supplied clothing clip allows you to attach
head when putting on make-up, hairspray and
the cable to your clothes, thus relieving the
more.Remove the cap before use.
cable draw to the headset mic. This is essential
on the single-ear headset mic.
Correct use of microphone grids
The two different protection grids that are supplied with 4066, 4067, and d:fine66 are
for acoustical equalization, depending on the placement on the performer. Remove the
premounted soft boost grid before replacing it with the high boost grid.
Color codes & cable steer
The d:fine
TM
Omnidirectional and d:fine Direc-
tional microphones come with a number of
Cleaning the mic grid of d:fine
cable steer clips in different colours. Mounted
Remove the microphone grid from the microphone element and clean the grid using a soft cloth
on the cable relief, this clip allows for quick rec-
and distilled water only. Make sure the grid is dry before remounting it on the microphone ele-
ognition of a specific headset microphone.
ment. This is not possible on the 4088 and d:fine
microphone housing and the protection grids are not removable. Therefore, no attempt should
be made to clean the grid surface and extreme care should be taken not to clog the grids with
makeup e.g.
TM
Omnidirec-
TM
TM
Directional, d:fine
66
TM
88.
TM
TM
4065, 4066, 4067 and d:fine
TM
88 as the diaphragm is protected inside the
Cable maintenance
The cable is usually longer than required. Make sure that superfluous cable is wound up
in soft figure-of-eight loops (preferably 6 – 8 cm (2.5 – 3 in) diameter) and avoid kinks
in the cable.
Use organic oil (e.g. olive oil) or lukewarm distilled water to remove residue from
tape, glue, or make-up on the cable. Do not bend the cable or rub it harshly, it may
stress the inner cores of the cable and cause them to break over time.
General Maintenance
The d:fine Headsets are resistant to high levels of humidity. However, care must
be taken to keep the headset microphone away from exposure to water and
cleaning fluids, and to keep the microphone head dry at all times. Do not use spray
or use fluid containing chemicals that could remove static electricity on or close to
the microphone. This could cause permanent damage.
66
MicroDot connectors and adapters
To provide users with safe and compact mounting of connec-
tors, all headsets from DPA are fitted with the MicroDot con-
nector as standard. A broad range of connection adapters is
offered as optional accessories for most wireless systems for
professional use. See www.dpamicrophones.com/adapters
Use the supplied connector-tightening tool whenever the
MicroDot connector needs to be fastened to the adapter for
long periods of time.
Advertisement
