Maintenance; Transporting And Storing Outboard Motor; Storing Outboard Motor; Conditioning And Stabilizing Gasoline - Yamaha F200 2015 Owner's Manual

Table of Contents

Advertisement

EMU41532
Transporting and storing out-
board motor
EWM02641
WARNING
 USE CARE when transporting fuel tank,
whether in a boat or car.
 DO NOT fill fuel container to maximum
capacity. Gasoline will expand consider-
ably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
 Leaking fuel is a fire hazard. Tighten se-
curely the fuel valve when transporting
and storing the outboard motor.
 Never get under the outboard motor
while it is tilted. Severe injury could oc-
cur if the outboard motor accidentally
falls.
 Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the outboard motor
cannot be trailered in the normal run-
ning position, use an additional support
device to secure it in the tilt position.
Leaking fuel is a fire hazard. When trailering
the boat, close the fuel valve to prevent fuel
from leaking.
The outboard motor should be transported
and stored in the normal running position. If
there is insufficient road clearance in this po-
sition, then trailer the outboard motor in the
tilt position using a motor support device
such as a transom saver bar. Consult your
Yamaha dealer for further details.
When the outboard motor is tilted prolonged
time for mooring or trailering the boat, close
the fuel valve.
EMU35412

Storing outboard motor

When storing your Yamaha outboard motor
for prolonged periods of time (2 months or
longer), several important procedures must
be performed to prevent excessive damage.
It is advisable to have your outboard motor
serviced by an authorized Yamaha dealer pri-
or to storage. However, you, the owner, with
a minimum of tools, can perform the follow-
ing procedures.
ECM01721
NOTICE
Store the outboard motor in a dry, well-
ventilated place, not in direct sunlight.
Keep the outboard motor in the attitude
shown when transporting and storing it.
EMU41382

Conditioning and stabilizing gasoline

When preparing to store a boat for extended
periods (2 months or longer) it is best to com-
pletely remove all gasoline from the boat's
fuel tank(s). If it is not possible to remove the
gasoline, add one ounce of "Yamalube Fuel
Stabilizer & Conditioner Plus" to each gallon
of gasoline in a full tank of gasoline to provide
fuel stability and corrosion protection.

Maintenance

ZMU07866
71

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lf200 2015

Table of Contents