Appliance Setup; Fixed Glass Assembly; Remove The Shipping Materials; Clean The Appliance - Heat & Glo MEZZO36 Installation Manual

11 11

Appliance Setup

A. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
1. Remove the decorative front from fi replace and set
aside on work surface.
2. Locate the glass latches that are on the upper edge of
the glass frame of the appliance. See Figure 11.1.
3. Use both index fi ngers to release the glass clips.
4. Allow glass to tilt forward. Grasp glass on the upper
return lip of glass frame and lift up and out. The glass
should lift easily out of the bottom retaining lip.
Replacing Fixed Glass Assembly
1. Locate retaining lip on lower front face of fi rebox.
2. Place glass assembly into retaining lip end. Tilt top of
glass assembly toward fi replace.
3. Assure proper left to right placement of glass and en-
gage all four spring latches.
GLASS CLIPS
BOTTOM RETAINING LIP
Figure 11.1 Fixed Glass Assembly
Heat & Glo • MEZZO36, MEZZO36ST, MEZZO48, MEZZO48ST Installation Manual • 2300-970 Rev. D • 6/14
50
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath
the fi rebox. Verify all components are with the fi replace.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Install Glass Refractory Panels
See-Through Models: Start at Step 3.
1. Single-Sided Models:
Set back glass panel, labeled A in Figure 11.2, into
fi rebox. Back panel will be held in place by the side
panels and will sit on the heads of the screws holding
the media tray in place. Set back glass panel against
the back wall of the fi rebox with the smooth side of the
glass facing outward. Hold back panel in place while
installing the left/right panels per step 2.
Set left side glass panel, labeled B in Figure 1, into
fi rebox with the smooth side facing outward. Insert a
retaining bracket through the slot in the inner fi rebox
heat shield. Line up the existing hole in the heat shield
with the hole closest to the bend in the bracket and
secure in place with a screw. Ensure the side glass re-
fractory panel is stationary. See Figure 11.3. Repeat
for right side panel.
2. See-Through Models:
Set left side glass panel, labeled B in Figure 11.2, into
fi rebox with the smooth side facing outward. Place re-
taining bracket over glass panel so holes in the brack-
et are against the fi rebox side. Use two self-drilling
screws to secure the bracket to the fi rebox side. See
Figure 11.4. Repeat for right side panel.
B
*Back panel used in single-sided models
Figure 11.2 Placement of Glass Panels
A* C