Advertisement
BIT
The SR sensor includes a built-in test feature. This feature is designed to allow operators to
identify HW or other faults that might result in reduced sensor performance or even prevent
the operation of the sensor.
Note – The BIT feature is not supported in all FW versions. In order to find out whether your
sensor supports BIT please contact the Magos support team.
BIT Mechanism
The built-in test contains 2 types of tests – continuous and periodic. Continuous tests are
run continuously. If the test fails BIT status is immediately reported. Periodic tests run
periodically (approx. once per minute).
In any event, regardless of test results, a BIT status report is sent periodically upon
completion of all periodic tests.
While all tests have a "Boolean" "Pass/Fail" result, most tests also report a numeric test
result if relevant.
To find out how to access the BIT status report, and depending on the control software you
use, please see:
MASS user guide – "BIT Status Report" chapter
•
Technician software user guide
•
SDK/ICD documentation
•
BIT Description
•
Jamming – Radar SW suspects a jamming attempt / an external interference. This
test is run continuously and any suspected jamming/interference is immediately
©2023, Magos Systems Ltd. All rights reserved.
Figure 10: Radar Manger – choosing a fixed IP
Advertisement
