Advertisement
Additional Physical guidelines
Make sure the sensor is stable and secure. The mounting solution should be stiff and
•
stationary under harsh wind conditions. As a general guideline, oscillations of more
than 3cm should not be allowed, or the unit's performance might be compromised.
If several sensors need to be installed next to each other, we recommend a distance
•
of at least 1m between the sensors when not aimed at each other (back-to-back
installation). Avoid aiming the sensors at each other when they are installed with less
than 150 meters distance between them.
Important!
Failure to observe the above restrictions might result in sensor performance
degradation and in extreme cases might lead to irreversible damage to thesensor units.
Connecting to the sensor: use outdoor weather immune cables. When the cable is
•
not plugged in, use the connector cap to maintain weather immunity. The warranty
does not cover weather damage (corrosion etc.) caused by the usage of improper
cables/failure to the use the cap when not installed. In such cases product warranty
is void. See chapter 5 for details on the sensor's electronic connection. Ensure that
the electronic connecting cable is firmly secured to the pole/wall or any other
contraption upon which the radar is installed in such a fashion that would not allow it
to dangle within the coverage area of the sensor. In addition, make sure that the
cable securing method renders it resistible to strong winds and that it does not apply
excessive force on the connector.
©2023, Magos Systems Ltd. All rights reserved.
Advertisement
