Advertisement
Electrical Installation Guidelines
The electrical installation of the sensor consists of a simple cable connection on the radar
side. Figure 8 contains the electrical schema of this cable.
For safety and warranty reasons users must use only cables supplied by Magos. Users must
also ensure that the connector shielding on the RJ45 connector side is
properly grounded.
Figure 8: SE-Series External operation cable
Power Supply Interface
Ensure that the SR-Series radar is powered only by an IEEE 802.3at Type 1 (802.3af) and
Type 2 certified POE injector/switch which is in conformance with all safety and EMC
standards that are relevant and applicable in your country. If you are unfamiliar with such
standards, it is recommended that you contact Magos and enquire as to the compatibility of
the suggested power supply. The electrical requirements of the power supply are according
to IEEE 802.3at Type 1 (802.3af) and Type 2.
Using power supplies that do not meet these requirements and/or are not properly
authorized for public use in your country is the sole responsibility of the user, and might
result in unexpected sensor behavior or even irreversible damage to the unit.
Important!
For safety reasons, prior to handling the connector on the radar unit, disconnect
the AC/DC converter or POE supply feeding the unit.
©2023, Magos Systems Ltd. All rights reserved.
Advertisement
