Biketec AG 500085 Instruction Manual page 49

INSTRUCTION MANUAL
Error code Displayed error message
FF-xx Permanent Battery Error
86-xx Speednode Software Error
87-xx Speednode Authentication Error
8C-06 Gears hardware error
Calibration required
8C-xx Gears hardware error
95-xx Charger Software Error
96-xx Charger Voltage Error
97-xx Charger Current Error
98-xx Charger Temperature Error
9A-xx Lock Authentication Error
9B-xx Lock blocked
FIT_Manual_Display_Compact_Remote_Basic_EShift_V2_en | Version 02 | 02.05.2023
FIT DISPLAY COMPACT + FIT REMOTE BASIC / ESHIFT
Action/limitation
1. Re-start the system.
2. Contact your specialist dealer if the problem
persists.
1. Re-start the system.
2. Contact your specialist dealer if the problem
persists.
1. Re-start the system.
2. Contact your specialist dealer if the problem
persists.
1. Calibrate the gears according to the instructions
in the corresponding operating instructions.
2. If the problem persists, please contact your
specialist dealer. .
1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
1. Check that the correct battery has been inserted
(36V / 48V).
2. Disconnect charger from system and socket.
3. Wait until the status LED goes out.
4. Plug charger into the socket again..
5. Plug charger into the system again.
6. Contact your specialist dealer if the problem
persists.
1. Check that the correct battery has been inserted
(36V / 48V).
2. Disconnect charger from system and socket.
3. Wait until the status LED goes out.
4. Plug charger into the socket again.
5. Plug charger into the system again.
6. Contact your specialist dealer if the problem
persists.
1. Check that the correct battery has been inserted
(36V / 48V).
2. Disconnect charger from system and socket.
3. Wait until the status LED goes out.
4. Plug charger into the socket again..
5. Plug charger into the system again.
6. Contact your specialist dealer if the problem
persists.
1. Disconnect charger from the battery.
2. Leave charger to cool down (> 30 minutes).
3. Start the charging process again.
4. Contact your specialist dealer if the problem
persists.
1. Check that an original FIT lock is installed.
2. Restart system.
3. Contact your specialist dealer if the problem
persists.
1. Restart system.
2. Check lock for dirt.
3. Contact your specialist dealer if the problem
persists.
49