Table of Contents
Advertisement
BASIC OPERATIONS
Configuring Network Settings
Note:
Before configuring network settings, make sure to connect the Wi-Fi dongle (optional), network module,
and/or Wi-Fi module (optional) to the IFP.
In the Settings menu, tap
•
Tap Ethernet to configure LAN settings and view the current connection status. In the IP settings section select
the network type between static and DHCP. If you set the network type as Static then tap
connection settings, such as IP address, gateway, network prefix length, and more.
IMPORTANT!
To connect to a wired network, the network module or the wireless network module with ethernet
must be installed on the IFP.
•
Tap Wi-Fi to connect the IFP to the Wi-Fi network and view current connection status. Make sure the
Wi-Fi function is enabled. In the Available network list, tap on your preferred Wi-Fi network, for example XXXX.
Provide an access password if needed.
IMPORTANT!
To connect to a Wi-Fi network, make sure the Wi-Fi dongle (optional) or Wi-Fi module (optional)
is properly connected to the IFP. For more information, refer to page
Note:
If your preferred Wi-Fi network is not visible in the list, tap
manually, tap
to open the Network menu, then complete the following steps:
.
28.
to refresh the list. To enter the Wi-Fi network
and enter the
45
English
Advertisement
Table of Contents
