Operation - Hisense H370BMI-WD User's Operation Manual

13

Operation

Starting up and temperature regulation
Insert the plug of the connection lead
●
into the plug socket with protective earth
contact. When the refrigerator
compartment door is opened, the internal
lighting is switched on. After the fridge
has been placed in position, wait for 5
minutes before electricity is supplied.
Don't store anything until the temperature
inside the fridge becomes low enough.
The temperature selector knob is
●
located on the top of the refrigerator
compartment.
Setting 0 means:
Off. The LED light is still on.
Clockwise rotate the knob to turn on
the appliance.
Setting 1 means:
Highest temperature. warmest setting.
Setting 7 (end-stop) means:
Lowest temperature, coldest setting.
Important! Normally we advise you
select setting of 2 or 3 or 4. if you want
the temperature higher or colder
please turn the knob to warmer or
colder setting accordingly.
When you turn the knob to colder which
can lead to the more energy efficiency.
Otherwise, it would result in more
energy-consuming.
NOTE: High temperature setting will
acceler ate food waste.
● For optimum food preservation, a
medium setting is generally suitable.
Important! High ambient temperatures
(e.g on hot summer days) and a cold
setting (position 6 to 7) may cause the
compressor to run continuously or
even non-stop!
0
Reason: when the ambient
temperature is high, the compressor
must run continuously to maintain
the low temperature in the appliance.
Changing theLED light
Changing the LED light carry out by
inexperienced persons may cause
injury or serious malfunctioning. it
must be replaced by a qualified
persons in order to avoid a hazard.
Contact your local Service Force
Center for help.
●
off the appliance and unplug it, or pull
the fuse or the circuit breaker.
●
●
●
backwards.
●
screw.
●
the defective LED light.
●
light cover and the screw.
●
operation.
Hisense Refrigerator
Warning! If the LED light is
damaged. DO NOT CHANG
IT BY THE USER!
Before changing the LED light, switch
LED light data: 220-240 V, max:1.5W.
Unplug the mains plug.
Press the LED light cover, and slide it
To change the LED light, undo the
Remove the bulb fixed block, change
Refit the bulb fixed block, the LED
Put the refrigerator back into
Bulb fixed block
Lampshade
Screw
Control Box
LED light