Installation And Operation - Hisense SC-242 User's Operation Manual

Installation and operation

Before use
Remove shipping package, tape, etc,
and leave doors open ventilation for a
while.
The unit is cleaned before shipment.
However, clean the compartment
interior once after delivery.
Please insert power supply plug into
the wall outlet ,single-phase to catch
voltage.
Allow the unit to operate for about 1
hour to cool the compartment before
placing items in the cooler.
Please let more than 10cm space
between the Showcase and wall. If
there are no space, cooling capacity
can drop down.
Wait 5 minutes or more before re-
starting
Restarting the unit immediately after it
has been turned off may cause fuses
to blow and activate the circuit-
breaker, the compressor may be
overloaded, and/or other damage may
occur.
Temperature adjustment
To adjust the temperature, turn the
knob clockwise to increase the
temperature, being the warmest
position 1 and 8 the coldest setting. To
reduce the temperature turn the knob
to the left. In the OFF position, the unit
will not operate.
Drain tray
23
10 cm
(back)
MIN
2
3
1
4
OFF 0
MAX
5
8
6
7
Defrosting is performed automatically
and drain water is collected in the
drain tray.
Water that is in the drain tray is
evaporated automatically. In humidity,
large amount of water in the drain tray,
so please throw away drain water once
a day.
Efficient use
Please follow the below instruction to
save energy:
To prevent cold air from escaping,
open and close the door quickly and
keep the door opened for as short a
time as possible.
Please install the unit in the place
which is well-ventilated.
Shelf height adjustment
The shelf height can be adjusted.
Arrange the shelves in accordance
with the dimensions of the items to be
placed in the cooler.
24