Rocsecure ROCSAFE Installation Instructions Manual page 10

authentication from the default Password Mode by
selecting the "Enable Token Login" option in the
Advanced Settings menu. Follow these steps to change
to Token Mode.
4. Go to the Advanced Settings menu and select the
"Enable Token Login" option.
5. When prompted, type in the current password and
the PIN (PASSWORD) for the token.
Note:
The default PIN for KeyCrypt token is "password".
IMPORTANT:
The number of WRONG PIN attempts
PIN is blocked is 8. The number of wrong PIN
attempts is only reset after you enter the correct PIN.
After KeyCrypt is blocked, you will not be able to use
KeyCrypt to log in. To continue using Rocsafe after
your KeyCrypt is blocked, you have to reset the
19
before KeyCrypt
account (see section on "Resetting Account") using
your Administrator Password.
Note: You can revert back to using password only by
selecting the "Enable Password Login" option.
3.5 Authentication in Token Mode
Once Rocsafe is in Token Mode, you will be prompted
for the token and the PIN (Password) instead of the
original password during authentication:
1. Insert the token into the USB port of the notebook
following the prompt.
2. When prompted, type in the PIN (PASSWORD) of
the token and press the "Enter" key.
Note:
The default PIN for KeyCrypt token is "password".
IMPORTANT Note: The number of wrong PIN attempts
before KeyCrypt PIN is blocked is 8. The number of
wrong PIN attempts is only reset after you enter the
correct PIN. After KeyCrypt is blocked, you will not be
able to use KeyCrypt to log in. To continue using
Rocsafe after your KeyCrypt is blocked, you have to
reset the account (see section
Account") using your Administrator Password.
IMPORTANT Note: If you leave the KeyCrypt token in
the USB port when the operating system boots up, the
operating system might prompt you to install
drivers for KeyCrypt. This is the default behavior
of the operating system. You can safely cancel
20
on "Resetting