Advertisement
Commissioning
Before Commissioning...... Check if the water inlet valve is opened. (Volume adjustment will be affected if it is not
1
Cover with a plastic film or similar device.
(Between the seat and toilet)
2
Check if the power plug is
plugged.
(The Power indicator is on.)
3
Press and hold the Electrical Leakage Test button for
2 seconds or longer.
The electrical leakage detection function is activated and
power is cut off. (The Electrical Leakage indicator is on
and the Power indicator is off.)
Off
4
Unplug the power plug.
Check if the Electrical Leakage
indicator is off.
5
After 5 seconds, plug the power plug.
The Power indicator will flash for approximately
10 seconds before remaining on.
Check if the water temperature is set to "Off".
Tips
When the Electrical Leakage indicator flashes, unplug the power plug immediately and contact your dealer or
one of Panasonic-operated service centers.
If you touch a closed seat (the Occupancy indicator is on and deodorization operate and unintentionally press the Rear
Showering / Front Showering button, water will come out and spray on yourself.
6
Press
or
The nozzle extends and the warm water tank of the body begins to pump in water. After approximately 1 minute,
water will flow out from the nozzle downwards. If no water flows out, check if the main water valve is opened or
the water inlet valve isn't opened sufficiently.
About idle running in the warm water tank
When carrying out Step ,
Temperature indicators all flash. This is not a malfunction.
[Do the followings]
Open the main water valve and water inlet valve. Start commissioning from Step
(The Water Temperature indicator is off.)
10
opened.)
Check if there is any water leaked from the connection.
On
On
Off
6
the warm water tank is running idle if the "High", "Mid" and "Low" Water
Step
Occupancy
switch (built-in)
8
On
2 4 5
Power plug
Off
6
again.
Plastic film
1 10
Advertisement
