Advertisement
About releasing water
The water flowing out next to the nozzle (water release
outlet) is the one released for pressure adjustment.
This is not a malfunction.
If the water release outlet is placed on the surface
of the toilet, water may not flow into the toilet. At
this time, install the body sightly forward. [Page 7]
7
9
6
7
Press
The nozzle retracts.
8
Press and hold the rear left portion of the seat. (The Occupancy indicator is on.) Meanwhile,
press
or
Deodorization starts. (with motor sound)
The nozzle starts self-cleaning. After approximately 5 - 8 seconds, cleaning water will be sprayed.
(If the Occupancy Switch is not enabled, no water will be sprayed.)
Check if cleaning water is sprayed normally with the plastic film.
9
Press
Once the nozzle retracts, water for nozzle self-cleaning will come out.
10
Remove the plastic film.
11
Press and hold the rear left portion of the seat.(The Occupancy indicator is on.) Meanwhile,
Press
, confirm warm air function , then press
12
Press
and
and water temperature.
It takes approximately 5 - 12 minutes for the temperature of the seat and warm water to stabilize.
(Depending on ambient temperature and the temperature of tap water.)
After showering stops, droplets will fall from around the nozzle. These are the water resulted from thermal expansion
of the warm water tank or water remaining in the nozzle. This is not a malfunction. (Approximately 7 - 8 minutes after
showering)
The Occupancy Switch is enabled when the seat is occupied
There is a gap
8
to set the temperature. After 5 -12 minutes, sit at the seat to check the seat
The back mount of the seat and the front leg are floating It is normal.
If this gap is not present, seating detection will not be detected.
Water release outlet
11
Occupancy indicator
.
3
11
Advertisement
