Advertisement
Installation of electric bidet seat
1
Remove the installed old seat.
Perform the removal operation by
following the Instructions provided
by the purchased toilet.
Example
Bolt
3
Install the body mounting plate.
The spacing for installing the bolts of the body mounting
plate can be adjusted between 130 - 215 mm.
1. Loosen the bolt and remove the nut. (Fig. 1)
Top-mounted
bolt
Loosen
Bolt
Remove
Nut
2. Fit the metal mounting plate to the top-mounted bolt
and screw in the nut. (Fig. 2)
(This nut is applicable to toilet with the bore diameter
of 12 - 17 mm . For other bore diameters, consult our
after-sales service for installation.)
3. For preliminary positioning, secure the top-mounted
bolt to the body mounting plate. (Same on both sides)
With a tape measure, measure the length of A. (Fig. 3)
Align the center line of the top-mounted bolt with the
reference scale line matching A on the body mounting
plate for preliminary positioning. (Fig. 4)
Fig. 3
Toilet mounting
hole
A
4. Adjust the position of the body mounting plate and
ensure B
80 mm. Then, install the body mounting plate
to the toilet.(Fig. 5)
Tighten
490
440
B
2
Remove the body mounting plate.
Press the body assembly / disassembly
button all the way in and remove the
body mounting plate.
(Pull out along the direction of
Unscrew
Do not press the nozzle
compartment.
(Otherwise, the nozzle may get
stuck.)
For proper installation, be sure
Seat
to use the body mounting plate
supplied with the product.
Fig. 1
Fig. 2
Metal mounting
plate
Fig. 4
Center line
490
490
(Example of
A=490 mm)
440
440
Fig. 5
490
440
80 mm
arrows alternatively.)
4
Install the body.
1. Align the protrusion in the center on the back side of
the body with the one in the center of the body
mounting plate.
2. Lift up the rear part of the body slightly and slide it
towards the body mounting plate until a "click" is
heard.
● Do not secure the power cord between the body and toilet.
Protrusion
When the rear part of the lid contacts the water tank
of the toilet, or the lifted seat falls down easily.
Move the body mounting plate forwards slightly and
secure it. Install the body again.
490
440
Nozzle compartment
Make sure to install the body mounting plate with
B
80 mm. Otherwise, the body may be tilted or a
water leak may occur.
Once the body is installed, lift it up gently to check if it is
installed securely.
As this product is design with a detachable structure to
enable the body to be removed from the toilet, it may
sometimes feel slightly shaky. This is not a malfunction.
Body assembly /
disassembly button
Protrusion
Front seat mount
Do not place the nozzle
compartment at the body base
on the surface of the toilet.
Make sure the front seat mount
is placed on the surface of the
toilet.
7
Advertisement
