Advertisement
Troubleshooting
Symptom
The Water Temperature
indicator flashes
"High", "Mid" and
"Low" at the same time
No water
Weak volume
adjustment
Water leaks from both
ends of the connection
of the water inlet hose
Power can't be supplied
Water flows out from
around the nozzle
The Power, 8-hour
Power Saving and "Mid"
Water
Temperature indicators
on the body flash at the
same time
Caution After Installation
Service information
Malaysia
Panasonic Malaysia
Lot 10, Street 13/2, 46200 Petaling Jaya, Selangor Darul Ehsan.
'+603-79537600
E-mail: ccc@my.panasonic.com
© Panasonic Corporation 2022
Printed in China
Possible Cause and Solution
The water inlet valve is not opened
The power plug is plugged before
the water inlet valve is opened
The inlet filter is clogged
The main water valve isn't opened sufficiently
The water inlet valve isn't opened
The water tank of the toilet is
pumping in water, leading to low
water pressure
The acorn nut isn't tightened
Gaskets or other devices shift
The quick fastener is not tightened
The O-ring on the
O-ring
front end of the
hose has dust
The Electrical Leakage Test button
is pressed or electrical leakage
occurred(The Electrical Leakage
indicator on the body is on)
During showering, the water flowing out next to the nozzle is the one released
for water pressure adjustment. This is not a malfunction.
Does the power plug wiggle when being plugged or unplugged?
→Unplug the power plug. After 5 seconds, plug it back
When these indicators still flash after removing and inserting the power plug
several times, contact your dealer or one of Panasonic-operated service
centers
When the product is likely not to be used for more than 1 week, drain it.
(Refer to "When Not Used for A Long Time " in the Operating Instructions.)
Open the water inlet valve. Plug
the power plug again. Re-start
commissioning.
Clean the filter
screen with a
toothbrush
Filter screen
Open the main water valve sufficiently
Open the water inlet valve
Wait until the water tank of the
toilet finishes pumping in water
Tighten the nut
Adjust the positions of gaskets
Tighten it securely
Remove dust from the O-ring
Unplug the power plug. After 5
seconds, insert it back
Ref. Page
10
Operation
Instructions
16
9
6
6
8
8
10
11
Advertisement
