Miller Kubota Big Blue 600 Pro Owner's Manual page 59

11-3. RPM Signal Failed Display
1
11-4. Service Reminder Screen
Wait to Start/Preheating
1
Service Reminder
Engine Oil
Compressor Oil
.
Glow plugs turn on automatically as de-
termined by ambient temperature.
Compressor oil information appears
only on models with air compressor.
1 Wait to Start/Preheating Display
The Wait to Start display appears when the
Engine Control switch is in the Run or Run/
Idle position and glow plugs are functioning.
The operator needs to pause at either
RPM SIGNAL FAILED
Hide
Remaining
0
0
switch position while the engine controller
goes through the preheat sequence. Once
this message clears, the engine can be
started.
2 Service Reminder Display
The Service Reminder display shows ser-
vicing intervals in hours counting down
from engine manufacturer recommended
service intervals. This display appears for
1 RPM Signal Failed Display
If the operator places the Engine
Control switch in the Run/Idle or
Run position and does not start the
engine, a timer starts. If this condi-
tion exists for 5 minutes or longer,
the RPM signal failed message ap-
pears. Place Engine Control switch
in Off position to reset.
Service Reminder Remaining
Engine Oil
Compressor Oil
a few seconds. It can also be found as a
1-up screen (see Section 11-7).
The 6-Up Display then appears as the de-
fault. The engine can be started when the
6-Up Display appears.
If the Enter/Diagnostic function button is
pressed while in this display, the DM2 dia-
gnostic screen appears. (see Section
11-10).
2
480
495
OM-272375 Page 55