Cleaning Unit; Routine Maintenance - Miller Kubota Big Blue 600 Pro Owner's Manual

8-2. Cleaning Unit

Clean unit exterior, including stainless steel if so equipped, frequently to prevent rust.
NOTICE − Use of a power washer is acceptable; however, cover or avoid electrical parts and the Engine Control Unit (ECU) located on the lower left
side of the center upright.

8-3. Routine Maintenance

n = Check
* To be done by Factory Authorized Service Agent
Every
FUEL
8
WATER
Hours
n Primary Fuel Filter
n Coolant Level
Every
100
Hours
~ Battery Terminals
Every
250
Hours
l Unreadable Labels
Every
500
Hours
Z Oil Z Oil Filter
NOTICE − Do not pre−fill
oil filters.
Every
1000
Hours
n~ Slip Rings*
nl Brushes*
Every
2000
Hours
lCoolant
.
Complete Parts List available at www.MillerWelds.com
Z = Change ~ = Clean
See engine
manual for fuel
specifications.
n Fuel Level
~ = Clean unit exterior, in-
cluding stainless steel, fre-
quently to prevent rust and
corrosion.
~ Weld Terminals
1/2 in.
(13 mm)
n Fan Belt Tension
NOTICE − Change engine
oil and filter after initial 50
to 75 hours of use.
See engine manual for oil
specifications.
OR
~ Inside Unit
NOTICE − Use Ethylene
Glycol coolant only.
See engine manual for
coolant specifications.
!
Stop engine before maintaining.
.
See Engine Manual and Maintenance Label
for important start-up, service, and storage
information. Service engine more often if
used in severe conditions.
l = Replace
n Oil Level ~ Oil, Fuel Spills
n Air Cleaner Hoses
n Air Cleaner Element
~ Cooling System n~Spark Arrestor
Z Fuel Filters nl Weld Cables
NOTICE − Do not pre−fill
fuel filters.
FUEL
SLUDGE
~ Drain Sludge
Reference
Section 5-5
and 8-4
Engine
Manual
Section
8-10, and
Engine
Manual
Section 8-5,
8-10, and
Engine
Manual
OM-272375 Page 41