Helmet Holder - Yamaha XJ6 2008 Owner's Manual

1
2
1. Projection
2. Seat holder
2. Push the rear of the seat down to
lock it in place.
3. Remove the key.
TIP
Make sure that the seat is properly se-
cured before riding.
INSTRUMENT AND CONTROL FUNCTIONS

Helmet holder

2
1
1. Helmet holder
2. Owner's tool kit
3. Helmet holding cable
The helmet holder is located under the
seat. A helmet holding cable is provid-
ed in the owner's tool kit to secure a
helmet to the helmet holder.
To secure a helmet to the helmet
holder
1. Remove the seat. (See page
4-16.)
2. Pass the helmet holding cable
through the buckle on the helmet
strap as shown, and then hook the
cable loop over the helmet holder.
4-17
EAU46750
1
3
1. Helmet
2. Helmet holding cable
3. Helmet holder
3. Place the helmet on the right side
of the vehicle, and then install the
seat. WARNING! Never ride with
a helmet attached to the helmet
holder, since the helmet may hit
objects, causing loss of control
and possibly an accident.
To release the helmet from the hel-
met holder
Remove the seat, remove the helmet
holding cable from the helmet holder
and the helmet, and then install the
seat.
2 3
4
[EWA10161]