Mitsubishi Electric MSZ-AY25VGKP-E6 Service Manual page 23

9-10. i-save ( ) OPERATION
1. How to set i-save operation
(1) Press OFF/ON (stop/operate) button.
(2) Select COOL, HEAT or ECONO COOL mode.
(3) Press i-save button.
(4) Set the temperature, fan speed, and airflow direction for i-save operation.
NOTE:
• i-save operation cannot be selected during DRY or AUTO mode operation.
• The setting range of HEAT mode i-save operation is 10 - 31°C.
• 2 groups of setting can be saved. (One for COOL/ECONO COOL, one for HEAT)
2. How to cancel operation
• Press i-save button again.
• i-save operation can also be cancelled by pressing Operation select button to change the operation mode.
The preferred setting can be saved for the next time with a single press of i-save button.
9-11. OPERATION LOCK
This function locks operation mode only. Other functions, such as OFF/ON, temperature setting, or airflow direction adjust-
ment, are available.
(1) Hold down button and
OPERATION LOCK.
The icon for the locked operation mode blinks.
(2) Hold down button and
OPERATION LOCK.
• The icon for the locked operation mode blinks when
OPERATION LOCK or
• AIR PURIFYING operation is not available when OPERATION LOCK is enabled in a mode other than FAN mode.
9-12. AIR PURIFYING ( ) OPERATION (MSZ-AY·VGKP)
In the AIR PURIFYING operation, the indoor unit built-in device reduces airborne fungi, viruses, mold, and allergens.
(1) Press PURIFIER button to start AIR PURIFYING operation.
• AIR PURIFYING lamp turns on. (Display section)
(2) Press PURIFIER button again to cancel AIR PURIFYING operation.
• AIR PURIFYING lamp turns off. (Display section)
NOTE:
• Never touch the air purifying device during operation. Although the air purifying device is safety-conscious design, touching
this device could be the cause of trouble as this device discharge high voltage electricity.
• A "hissing" sound may be heard during the air purifying operation. This sound is produced when plasma is being dis-
charged. This is not a malfunction.
• AIR PURIFYING lamp does not turn on if the front panel is not closed completely.
9-13. SELF CLEAN (
• When SELF CLEAN operation is set, it performs for 25 minutes when unit is stopped after COOL/DRY operation.
SELF CLEAN operation performs when: COOL/DRY is operated more than 3 minutes.
• The fan is stopped for the first 3 minutes. Then, the horizontal vane is set to higher than angle 1 and the fan is operated for
25 minutes.
OBH930
button simultaneously for 2 seconds while the unit is not operating to enable
button simultaneously for 2 seconds again while the unit is not operating to disable
button is pressed during operation while OPERATION LOCK is enabled.
) OPERATION
button and button are held down to enable or disable
23