Mitsubishi Electric MSZ-AY25VGKP-E6 Service Manual page 13

3-2. Setting up in Access Point mode
Complete the setting up in the Access Point mode within
10 minutes.
To enter the mode
(1) Hold down the Temperature
for 5 seconds.
(2) Select "¯ 1" by pressing
Temperature and
on the right.
(3) Point the remote controller
toward the indoor unit unit and
press the .
3-2.1. Connect your smartphone to the air conditioner.
Make sure that the LED indication is as shown below.
On the Wi-Fi Setting Screen on your smartphone,
select SSID and enter KEY, which are printed on the
information label.
MAC: XXXXXXXXXXXX
ID: XXXXXXXXXX
SSID: SSID: ME-XXXXXXXXXX ME-XXXXXXXXXX
KEY: KEY: XXXXXXXXXXXX XXXXXXXXXXXX
E.O.
SW
Wi-Fi interface Other Smartphone
NOTE:
• Check Wi-Fi setting of your smartphone if SSID does not
appear on it.
• Enter KEY again if SSID appears on your smartphone,
but it cannot connect to the Wi-Fi interface.
• The LED indication does not change or blinks 5 times if
connection fails. In that case, reset connection and set
up the Wi-Fi interface and the router again.
3-2.2. Access URL (http://192.168.11.1/network) by any of
the following methods to display the setting screen.
(1) Scan the matrix barcode below.
(2) Scan the matrix barcode on the information label.
(3) Type the URL (http://192.168.11.1/network) in the
web browser.
Information label
MAC: XXXXXXXXXXXX
ID: XXXXXXXXXX
SSID: ME-XXXXXXXXXX
KEY: XXXXXXXXXXXX
E.O.
Other
SW
Wi-Fi interface
OBH930
Access Point mode
as shown
Connecting
The LED lights up for 3 seconds
then blinks once.
A beep sounds as the LED blinks.
This series of actions is repeated.
3-2.3. Register the information of the router on the air
conditioner.
In the displayed window, select Dynamic in
DHCP (*1) and enter the information of router,
then tap the Submit button.
(*1)
Router
NOTE:
• If you want to use Static, select Static in DHCP (*1) and
enter the information of router and network, then tap the
Submit button.
3-2.4. LED indication will be as shown below when
connection between the router and Wi-Fi interface is
completed and connection to MELCloud starts.
Connected
Connecting
NOTE:
It may take several minutes to show the indication above.
The LED indication does not change or blinks 5 times if
connection fails.
In that case, reset connection and set up the Wi-Fi interface
and the router again.
13
Connecting
Connecting
MELCloud
The LED lights up for 5 seconds and
then a beep sounds for 1 second.