Mitsubishi Electric MSZ-AY25VGKP-E6 Service Manual page 22

(3) Press , , and
Pressing
selects ON/OFF timer.
Pressing
deletes timer setting.
* Hold down the button to change the time quickly.
* The temperature can be set between 16°C and 31°C at cool operation.
* The temperature can be set between 10°C and 31°C at heat operation.
Press and
(4) Press button to complete and transmit the weekly timer setting.
NOTE:
• Press button to transmit the setting information of weekly timer to the indoor unit. Point the remote controller toward
the indoor unit for 3 seconds.
• When setting the timer for more than one day of the week or one number,
each setting. Press
• Press button to enter the weekly timer setting mode, and press and hold
weekly timer settings. Point the remote controller toward the indoor unit.
(5) Press
button to turn the weekly timer ON. (
• When the weekly timer is ON, the day of the week whose timer setting is complete, will light.
Press button again to turn the weekly timer OFF. (
NOTE:
The saved settings will not be cleared when the weekly timer is turned OFF.
2. Checking weekly timer setting
(1) Press button to enter the weekly timer setting mode.
* blinks.
(2) Press or
(3) Press button to exit the weekly timer setting.
NOTE:
When all days of the week are selected to view the settings and a different setting is included among them,
be displayed.
9-9. NIGHT MODE ( ) OPERATION
NIGHT MODE changes the brightness of the operation indicator, disables the beep sound and limits the noise level of the
outdoor unit.
(1) Press NIGHT MODE button during operation to activate NIGHT MODE ( ).
• The operation indicator lamp dims.
• The beep sound will be disabled except that emitted when the operation is started or stopped.
• Noise level of the outdoor unit will be lower than that mentioned in SPECIFICATIONS. (Except the connection to
MXZ.)
(2) Press NIGHT MODE button to cancel NIGHT MODE ( ).
NOTE:
• Noise level of the outdoor unit may not change after startup of the unit, during the protection operation, or depending on
other operating conditions.
• The fan speed of the indoor unit will not change.
• The operation indicator lamp will be hard to be seen in a bright room.
• Noise level of the outdoor unit will not decrease during Multi system operation.
OBH930
buttons to set ON/OFF, time, and temperature.
E.g. : [ON], [6:00]
Pressing
Pressing
adjusts the time.
adjusts the
temperature.
buttons to continue setting the timer for other days and/or numbers.
* which was blinking
goes out, and the current
time will be displayed.
button once after all the settings are complete. All the weekly timer settings will be saved.
buttons to view the setting of the particular day or number.
and [24°C] are
selected.
lights.)
goes out.)
22
button does not have to be pressed per
button for 5 seconds to erase all
will