Table of Contents
Advertisement
TROUBLESHOOTING
54
EN
Warning Indications
Displays the battery remaining power.
Remaining power level
High
As the battery power comes close to nil, the
battery remaining power indicator blinks.
When the battery power is exhausted, power
turns off automatically.
The battery remaining power indicator display
should only be used as a guide.
When the remaining recordable time is more
than 30 minutes, it is displayed in 10-minute
units and when the time is less than 30 minutes,
it is displayed in 5-minute units.
Appears when no tape is loaded. (
CHECK TAPE'S ERASE PROTECTION TAB
Appears when the erase protection tab is set to
"SAVE" while the power switch is set to "A" or
"M" and the VIDEO/MEMORY switch is set to
"VIDEO". (
pg. 14, 17)
USE CLEANING CASSETTE
Appears if dirt is detected on the heads during
recording. Use an optional cleaning cassette.
(
pg. 58)
CONDENSATION, OPERATION PAUSED
PLEASE WAIT
Appears if condensation occurs. When this
indication is displayed, wait more than 1 hour
until condensation disappears.
TAPE!
Appears if a tape is not loaded when the
recording start/stop button or SNAPSHOT
button is pressed while the power switch is set to
"A" or "M" and the VIDEO/MEMORY switch is
set to "VIDEO".
TAPE END
Appears when the tape ends during recording or
playback.
SET DATE/TIME!
● Appears when the date/time is not set.
(
pg. 15)
● The built-in clock battery has run out and the
previously set date/time has been erased.
Consult your nearest JVC dealer for
replacement.
Exhausted
LENS CAP
Appears for 5 seconds after power is turned on if
the lens cap is attached or when it is dark.
A. DUB ERROR!
Appears if audio dubbing is attempted on a
blank portion of a tape. (
A. DUB ERROR!
<CANNOT DUB ON A LP RECORDED TAPE>
<CANNOT DUB ON A 16BIT RECORDING>
<CHECK TAPE'S ERASE PROTECTION TAB>
pg. 16)
● Appears if audio dubbing is attempted on a
tape recorded in the LP mode. (
● Appears if audio dubbing is attempted on a
tape recorded in 16-BIT audio. (
● Appears if A. DUB (D) on the remote control is
pressed when the erase protection tab is set to
"SAVE". (
pg. 50)
pg. 50)
pg. 50)
pg. 50)
Advertisement
Table of Contents
