JVC GR-X5AC Instructions Manual page 53

Other problems
The POWER/CHARGE lamp on the camcorder
does not light during charging.
● Charging is difficult in places subject to extremely
high/low temperatures.
HTo protect the battery, it is recommended to
charge it in places with a temperature of 10°C to
35°C. ( pg. 57)
● The battery pack is not attached firmly.
HDetach the battery pack once again and re-attach
it firmly. ( pg. 13)
"SET DATE/TIME!" appears.
● The date/time is not set.
HSet the date/time. (
● The built-in clock battery has run out and the
previously set date/time has been erased.
HConsult your nearest JVC dealer for replacement.
Files stored in the memory card cannot be
deleted.
● Files stored in the memory card are protected.
HRemove protection from the files stored in the
memory card and delete them. (
When the image is printed from the printer, a
black bar appears at the bottom of the screen.
● This is not a malfunction.
HBy recording with "DIS" activated (
this can be avoided.
When the camcorder is connected via the DV
connector, the camcorder does not operate.
● The DV cable was plugged/unplugged with power
turned on.
HTurn the camcorder's power off and on again,
then operate it.
When connected to the PC with a DV cable, the
image data is not transferred.
● The VIDEO/MEMORY switch is set to
"MEMORY".
HSet the VIDEO/MEMORY switch to "VIDEO".
pg. 15)
pg. 28)
pg. 33, 34)
TROUBLESHOOTING
Images on the LCD monitor appear dark or
whitish.
● In places subject to low temperature, images
become dark due to the characteristics of the
LCD monitor. This is not a malfunction.
HAdjust the brightness and angle of the LCD
monitor. ( pg. 12, 16)
● When the LCD monitor's fluorescent light reaches
the end of its service life, images on the LCD
monitor become dark.
HConsult your nearest JVC dealer.
Coloured bright spots appear all over the LCD
monitor.
● The LCD monitor is made with high-precision
technology. However, black spots or bright spots
of light (red, green or blue) may appear constantly
on the LCD monitor. These spots are not
recorded on the tape. This is not due to any
defect of the unit. (Effective dots: more than
99.99%)
The cassette will not load properly.
● The battery's charge is low.
HInstall a fully charged battery. (
The memory card cannot be removed from the
camcorder.
HPush in the memory card a few more times.
( pg. 17)
Picture does not appear on the LCD monitor.
● The LCD monitor's brightness setting is too dark.
HAdjust the brightness of the LCD monitor.
( pg. 16)
An error indication (01 – 04 or 06) appears.
● A malfunction of some kind has occured. In this
case the camcorder's functions become
unusable.
H
pg. 56.
The remote control does not work.
● "REMOTE" is set to "OFF".
HSet "REMOTE" to "ON". (
● The remote control does not point at the remote
sensor.
HPoint at the remote sensor. (
● The remote control batteries are exhausted.
HReplace the batteries with fresh ones. (
53
EN
pg. 13)
pg. 33, 35)
pg. 23)
pg. 23)