Volvo S90 2019 Owner's Manual page 567

The rectangular section of the clip points toward the
front and rear of the vehicle.
5. To remove a clip: Insert a flat object (e.g.
kitchen knifes or screwdrivers) into both
short sides of the clip to release both
catches at the same time and then pry
and pull out the clip.
The hinge's plastic cover is held into place by a plas-
tic clip and three latches.
6. To remove the hinge's plastic cover on the
side in which the fog light is mounted:
Press down the pin in the center of the
plastic clip using a screwdriver or similar.
Pry/pull out the plastic clip.
7. Release the plastic cover's three latches
using e.g. a small screwdriver and remove
the plastic cover.
MAINTENANCE AND SERVICE
8. Carefully pry and pull down the loosened
section of panel to access the bulb.
NOTE
To bear in mind when reinstalling the plas-
tic rivet for the plastic guard of the hinge:
Before the plastic rivet can be used for
•
reinstallation, its center pin must first be
pressed back far enough that it pro-
trudes from the plastic rivet.
Once the plastic guard of the hinge is
•
secured in position, press the plastic
rivet into the hole of the plastic guard.
Finally, the pin is pressed into the plas-
•
tic rivet until its end surface is in line
with the surface of the plastic rivet.
}}
565