Volvo S90 2019 Owner's Manual page 432

Hide thumbs Also See for S90 2019:
Table of Contents

Advertisement

STARTING AND DRIVING
Activating and deactivating the
compass*
25
An integrated compass
corner of the rearview mirror shows the
direction the vehicle is traveling.
The compass is automatically activated when
the vehicle is started.
To deactivate/activate the compass manually:
Use a paper clip or similar object to press
the button on the bottom of the mirror.
> If the compass is deactivated when the
vehicle is switched off, it will not be
activated the next time the vehicle is
started. The compass will then need to
be activated manually.
Related information
Compass* (p. 429)
Calibrating the compass* (p. 430)
25
Rearview mirror with compass is available as an option only on certain markets and models.
26
Rearview mirror with compass is available as an option only on certain markets and models.
430
Calibrating the compass*
The globe is divided into 15 magnetic zones.
The compass
in the upper right
vehicle is driven from one zone to another.
1.
Stop the vehicle in a large, open area away
from steel constructions and high-voltage
power lines.
2. Start the engine and switch off all electri-
cal equipment (climate system, wipers,
etc.) and make sure all doors are closed.
Calibration may fail or not even be initiated
if electrical equipment is not turned off.
3. Hold the button on the bottom of the rear-
view mirror pressed for about 3 seconds
(using e.g. a paper clip). The number of the
current magnetic zone is shown.
26
should be calibrated if the
NOTE
1
2
3
4
5
8
6
7
Magnetic zones.
4. Press the button on the underside of the
mirror repeatedly until the desired mag-
netic zone (
1–15
) appears (see the map of
magnetic zones).
5. Wait until the display again shows
press and hold the button on the under-
side of the rearview mirror for approx.
6 seconds until
C
is displayed.
6. Drive slowly in a circle at a speed of no
more than 10 km/h (6 mph) until a com-
pass direction is shown in the display. This
indicates that calibration is complete.
Drive in a circle two more times to fine-
tune the calibration.
* Option/accessory.
15
14
13
12
11
9
10
C
, or

Advertisement

Table of Contents
loading

Table of Contents