Removing the plastic cover to
replace bulbs
The headlight bulbs can be replaced without
the assistance of a workshop, but before a
bulb can be replaced, the plastic cover over
the headlight needs to be removed.
Release the pins in the plastic cover's four
–
clips by pressing them down with a
screwdriver or similar object and remove
the covering.
18
LED (Light Emmitting Diode)
NOTE
To bear in mind when refitting the cover-
ing:
The pin in the clip must be pressed
•
back completely before the clip is rein-
stalled in the covering.
When the covering is reinstalled, the
•
pin must be pressed in until the end
surface is level with the surface of the
clip.
Related information
Replacing bulbs (p. 558)
•
Replacing the low beam headlight bulbs
•
(p. 560)
Replacing the high beam headlight bulbs
•
(p. 561)
Replacing daytime running lights/front
•
parking light bulbs (p. 562)
Replacing front turn signal bulbs
•
(p. 563)
Bulb specifications (p. 566)
•
MAINTENANCE AND SERVICE
Location of exterior lights
The vehicle's exterior lighting consists of sev-
18
eral different bulbs. LED
bulbs must be
replaced by a workshop. An authorized Volvo
workshop is recommended.
Front bulbs (vehicles with halogen
headlights)
Low beams
High beams
Daytime running light/parking light
Turn signal
Front fog light/cornering illumination*
(LED)
* Option/accessory.
}}
559