Left headlight.
1.
Remove the low beam rubber cover from
the headlight housing.
2. Remove the connector from the bulb.
3. Remove the bulb by pressing it slightly
upward and then pulling it out.
4. Insert the new bulb in the socket. The
bulb's guiding pin should point straight
up.
5. Press the connector into place.
6. Put the rubber cover back in place.
Related information
Location of exterior lights (p. 559)
•
Removing the plastic cover to replace
•
bulbs (p. 559)
Bulb specifications (p. 566)
•
Replacing the high beam headlight
bulbs
The high beam bulbs in the halogen head-
lights can be changed without the help of a
workshop.
Before the bulbs can be replaced, the plastic
covering over the headlight must be removed.
CAUTION
Never touch the bulb glass with your bare
fingers. Grease and oils from your fingers
vaporize in the heat and will leave a
deposit on the reflector, which may dam-
age it.
Left headlight.
1.
Remove the high beam rubber cover from
the headlight housing.
MAINTENANCE AND SERVICE
2. Remove the bulb by turning the bulb
holder upward and then pulling it straight
out.
3. Carefully pry the plastic sleeve by the con-
nector's locking lug to release it.
4. Remove the connector from the bulb.
5. Replace the bulb.
6. Position the bulb in the socket and turn it
downward.
7. Put the rubber cover back in place.
Related information
Location of exterior lights (p. 559)
•
Removing the plastic cover to replace
•
bulbs (p. 559)
Bulb specifications (p. 566)
•
561