Table of Contents
Advertisement
Chapter V Disassembly & Repair
Chapter V Disassembly & Repair
c. Check of float height
Place carburetor according to the figure and push in the float
Place carburetor according to the figure and push in the float
with fingers.
When the float valve touches the float seat and the spring
When the float valve touches the float seat and
doesn't compress, measure the dimensions between float and
doesn't compress, measure the dimensions between float and
the shell (height of the float).
Standard height
When the height of float is inconsistent
d. Clean the carburetor
Warning
When using the compression air, to
hen using the compression air, to avoid injury, wear
protective spectacles or other protective equipment.
protective spectacles or other protective equipment.
Note
Some chemical solvents are of relatively
chemical solvents are of relatively-strong corrosivity
and may damage plastic parts such as the O
and may damage plastic parts such as the O-ring and float.
Please carefully read the Solvents Manual.
lease carefully read the Solvents Manual. Should you not
confirm, don't use the solvent to clean the carburetor. The
use the solvent to clean the carburetor. The
compression air of high pressure may also damage the
compression air of high pressure may also damage
carburetor. Please remove the dirt in
lease remove the dirt in the passage or pipe
mouth with compression air of proper pressure.
mouth with compression air of proper pressure.
1) Clean the carburetor with cleanser.
2) Blow in the compression air to remove dirt in idl
compression air to remove dirt in idle air jet, idle jet, air jet, main jet, main nozzle, etc. prior to
installation.
14 ±1.5 mm
mm
with the specified value, replace the float or float valve.
with the specified value, replace the float or float valve.
- 42 -
Special tool
Float height gauge
jet, main nozzle, etc. prior to
Hide quick links:
Advertisement
Table of Contents
