Table of Contents
Advertisement
Chapter V Disassembly & Repair
Disassembly/assembly
Note: clean the carburetor prior to installation
Idle mixture adjusting screw
Assembly:
Check the wear at the front
before installation.
Carburetor body
Assembly:
Blow in compressed air
and remove dirt in the
passage before installation.
Throttle-valve shaft
Primary nozzle
Assembly:
Blow in compressed
air and remove dirt in
the passage prior to
installation.
Oil drain plug of oil cup
Confirm if there is
fuel
leakage
installation.
Float
Assembly:
Touch with finger
after installation to
confirm its action.
Electron magnetic valve
after
Float chamber
Idle jet
Assembly:
Clean thoroughly with compressed air
before installation and slightly lubricate
the O-ring.
Float pin
Float pin
- 41 -
O-ring
Choke-valve shaft
Needle valve
Assembly:
Check the wear of the end and
action
of
spring
installation.
Needle-valve seat
Needle valve
Main jet
Normal
Primary nozzle
Assembly:
Blow in compressed air
and remove dirt in the
passage
before
installation.
before
Replace
Hide quick links:
Advertisement
Table of Contents
