Install The Rimage Software; Connect The Cables - Rimage Autostar II Reference Manual

6
Place the printer on the Rimage autoloader.
Place the printer on your Rimage autoloader so that the printer feet slide
into the slots on the printer plate.
Printer Plate
7

Connect the cables.

At the back of the printer connect the following cables:
• Printer cable
• Printer power cord
• USB cable
Everest printer
Printer Cable
Printer Power Cord
OR
Prism printer
Printer Cable
©
Copyright 2007 Rimage Corporation
Slots
USB Cable
USB Cable
Printer Power Cord
8
Power on the Rimage autoloader.
a. Connect the autoloader power cord to the power outlet.
b. Press the autoloader power switch to power on the system.
9

Install the Rimage software.

If your printer was shipped to you with a Rimage software disc, install the
software on the embedded or external control center.

Important! Be sure to uninstall any previous Rimage software before
installing your new software.
10
Install the printer driver (Everest III only).
If your new printer is an Everest III, follow the prompts in the New
Hardware Wizard to add the printer to your list of available printers.
11
Update the autoloader or AutoPrinter firmware.
Install the latest autoloader or AutoPrinter firmware. Firmware and
instructions are available at Rimage.com/Support.html. Navigate:
Product Family > Support - Product > Downloads tab.

Important! If you are replacing a Prism printer with an Everest III
printer, refer to the Updating Printer Firmware using Gemini Utilities
document (PN 2000759) included with your new printer.
12
If necessary, align the printer to the Rimage
autoloader.
Refer to the instructions in the user guide that was included with your
Rimage autoloader. User guides are also available at www.Rimage.
com/Support.html. Navigate: Product Family > Support - Product >
Documents tab.
Your Rimage autoloader is ready for use.
2000584_B