Panasonic WV-SFV110 Installation Manual page 10

Keep SDXC/SDHC/SD memory cards
away from infants and children.
Otherwise, they may swallow the cards by
mistake.
In this case, consult a doctor immediately.
Do not install or clean the camera, or
touch this product, the power cable or the
connected cables during thunder storms.
Failure to observe this may cause electric
shock.
Install this product in a location high
enough to avoid people and objects from
bumping the product.
Failure to observe this may cause injury.
Do not hang down from this product or
use this product as a pedestal.
Failure to observe this may cause a drop
resulting in accidents.
Correctly perform all wiring
Short circuits in the wiring or incorrect wiring
may cause fire or electrical shock.
Turn the power off when cleaning this
product.
Failure to observe this may cause injury.
Do not rub the edges of metal parts with
your hand.
Failure to observe this may cause injury.
[Precautions for use]
To keep on using with stable performance
Do not use this product in hot and humid con-
ditions for a long time. Failure to observe this
causes component degradation resulting in life
shortening of this product. Do not expose this
product to direct heat sources such as a heater.
This product has no power switch.
When turning off the power, disconnect the
Ethernet cable from the PoE device or turn off
the power of the PoE device.
10
Handle this product with care.
Do not drop this product, nor apply shock or
vibration to the product. Failure to observe this
may cause trouble.
If a strong shock or vibration is applied to the
enclosure, it may cause damage or allow water
to enter this product.
About the battery
A battery is installed inside the camera. Do not
leave the battery exposed in environments of
excessive heat as a result of sunlight or fire.
Do not touch the dome cover directly with
your bare hands.
A dirty dome cover causes deterioration of pic-
ture quality.
About the PC monitor
When displaying the same image on the monitor
for a long time, the monitor may be damaged.
It is recommended to use a screen-saver.
When an error is detected, this product
will restart automatically.
This product will be inoperable for around 2
minutes after the restart just as when the
power is turned on.
About the automatic status detection
function
When this product malfunctions due to exoge-
nous noise, etc. for 30 seconds or more, the
product will automatically reset and will return
to normal state. When the product is reset, ini-
tialization will be carried out as when the power
of the product is turned on. When the product
repeatedly resets, exogenous noise level
around the product may be high and that may
cause malfunction. Contact your dealer for
instructions.
Transmission interval
Image transmission interval may become slow
depending on the network environment, PC per-
formance, shooting subject, access number, etc.