Table of Contents
Advertisement
No.
Mode
8
Jump Table
9
Drm Stp Mode
10
Long Sheet Mode You can select whether you can use paper longer than
11
Skip Number of
Time
12
Skip Display On
Mode
13
Total Counter
Down
14
Print Position
15
Feed Setup
Description
You can change the angle of the wing guide depending on the pa-
per type you use.
Note
❒ Default: Auto
❒ Available settings:
• Up (Select this setting when standard thickness or thin pa-
per misfeeds at the paper exit section occur frequently.)
• Down (Select this setting when A4-B5, 8
per is not delivered properly to the paper delivery tray.)
You can select the drum which you will be able to pull out imme-
diately after you finish your job without pressing any key.
Note
❒ Default: Drum 1
432mm,17.0" or not.
Note
❒ Default: Not to use
❒ When you use paper longer than 432mm, 17.0", lower the pa-
per delivery end plate and receive completed prints by hand.
Specifies the number of drum rotations in Skip Feed mode when
the power is turned on.
You can also select whether you can change the number of drum
rotations temporarily when you press the {Skip Feed} key. ⇒ P.23
"Skip Feed Printing"
Note
❒ Default:
• Number of Skip Feed: 2
When you press {Skip Feed} key, you can select whether optional
print counts display shows up or not.
Note
❒ Default: Off
The copy counter can be set to show the number of copies made
(Count Up), or the number of copies remaining to be made
(Count Down).
Note
❒ Default: Yes (Count Down)
You can register the settings of print image position.
You can register the settings for frequently use.
User Tools
" × 11" thick pa-
1
/
2
27
2
Advertisement
Table of Contents
