Larson Electronics EPL-TP-2XRUL10 Instruction Manual

Explosion proof rechargeable light tower two portable light heads 16 hour runtime

Advertisement

Quick Links

Do not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within this
instruction sheet. Read carefully before operating. Retain these instructions for future reference.
The EPL-TP-2XRUL10 Explosion Proof Rechargeable LED Light Tower is Class 1 Divisions 1 & 2 and Class 2 Divisions 1
& 2 approved and provides up to 16 hours of runtime on a single charge. Two high output removable LED assemblies,
versatile charging options, lithium-ion batteries, and articulating lamp heads are only a few of its features. The durability
and power of this rechargeable portable light tower make it ideal for applications including emergency services, utility
work, hazardous locations and more. With proper care and maintenance, this light tower will provide long, dependable
service. Please take a moment to read this instruction sheet before using your new lantern. It provides important safety
and operating instructions.
NOTICE
Before using the lantern or battery charger, read all instructions and cautionary markings on the unit.
CAUTION: Do not attempt to use that charger to recharge any other product. Also do not attempt to use any other
charger to recharge your lantern.
Do not operate a damaged charger. Replace damaged cords or charger immediately. Do not try to repair a
damaged lantern or charger yourself. Should your charger fail to operate for any reason, contact our service
center, Larson Electronics at 1-800-369-6671, for further instructions.
Do not abuse the cord. Never carry the charger by the cord or disconnect the charger from a receptacle by
pulling the cord.
Unplug power adapter and remove lantern from charger before performing any routine cleaning or maintenance.
Do not place any metal objects onto the charging terminal located in the charger.
Do not incinerate or leave the battery pack near a heat source such as a radiator, fireplace, stove, or any other
heat-generating appliance. When exposed to high temperatures, the battery pack could explode and possibly
cause a fire.
Do not disassemble or mistreat a battery pack or store a battery pack where it could come in contact with
metal objects that could short circuit the battery pack terminals. The resulting current can cause high
temperatures and damage to the battery pack and also can cause burns and possibly fire.
Please refer to local ordinances concerning battery recycling and disposal.
Use of this product for other than a lighting device is not recommended. Manufacturer specifically
disclaims liability for other than recommended use.
The direct wire feature for this charger is intended for power sources between 12 to 24VDC. Attempting to
direct wire to any other power source will cause severe damage to the charger.
Be sure to check the AC adapter voltage rating to ensure that the required voltage and frequency match the
available power source. On the right side of the lantern is a low battery LED indicator.
*For 4 and 6 cell lanterns, approximately 30 minutes of runtime remains when the indicator is activated.
*For 8 cell lanterns, approximately 60 minutes of runtime remains when the indicator is activated.
If your lantern includes a carrying strap, attach the strap to the rings using the quick connect clips provided
on the strap.
Larson Electronics, LLC
Explosion Proof Rechargeable Light Tower
Two Portable Light Heads - 16 Hour Runtime
Instruction Manual
Phone: (800) 369-6671
Fax: (903) 498-3364
EPL-TP-2XRUL10
www.larsonelectronics.com
1 of 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EPL-TP-2XRUL10 and is the answer not in the manual?

Questions and answers

Summary of Contents for Larson Electronics EPL-TP-2XRUL10

  • Page 1 Read carefully before operating. Retain these instructions for future reference. The EPL-TP-2XRUL10 Explosion Proof Rechargeable LED Light Tower is Class 1 Divisions 1 & 2 and Class 2 Divisions 1 & 2 approved and provides up to 16 hours of runtime on a single charge. Two high output removable LED assemblies, versatile charging options, lithium-ion batteries, and articulating lamp heads are only a few of its features.
  • Page 2 6. Be sure to screw the lens ring assembly on firmly, but do not over-tighten. 7. Check O-ring each time bulb is replaced. If necessary, lubricate O-ring and inside lip of lens ring with silicone grease. 8. Replace worn, scratched or cracked O-rings. Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com...
  • Page 3 Inspect for good working condition prior to storage and before re-use. These instructions may not cover all details or variations of this product for your equipment or installation requirements. Should further information not covered by these instructions be required, please contact Larson Electronics by email at sales@larsonelectronics.com or by phone at 1-800-369-6671 for further assistance.

Table of Contents