Ricoh CL4000DN Maintenance Manual page 84

Troubleshooting
Messages
Change Setting
Tray #
/ Paper Size:
Paper Type:
Check Toner Btl.
XXX/XXX
Close
Top Cover
Close
Front/Left Cover
Cooling down...
DHCP assigned
Cannot change
Energy Save Mode
Error: Enter 10
or 26 characters
Error: Enter 5
or 13 characters
Hardware Problem
Ethernet
Hardware Problem
HDD
Description
The paper size and type set-
ting in the tray differs from that
of actual paper size and type in
the tray.
The indicated toner cartridge
is not set correctly.
XXX: Yellow/Magenta/Cy-
an/Black
The top cover is open.
The front cover or left cover is
open.
The waste toner bottle is not
set correctly, or not set.
The printer is cooling down.
An attempt to change the IP
address, subnet mask or gate-
way address was made while
DHCP was set to [On].
In Energy Save Mode level 2.
An ID with an invalid number of
digits was entered for the WEP
key.
An ID with an invalid number of
digits was entered for the WEP
key.
The printer identified an Ether-
net error.
The printer identified a HDD
Board error.
Recommended Action
Load paper of the selected
size in the tray, and then
change the paper size setting
with the control panel. Or,
press {Form Feed}, and then
select the tray using the con-
trol panel. Or, press {Job Re-
set} to cancel the print job.
Set the indicated toner car-
tridge(s) correctly.
See p.32 "Replacing the Ton-
er Cartridge".
Close the top cover.
Close the front cover or left
cover.
Set the waste toner bottle cor-
rectly.
Wait a while.
Make the change after setting
DHCP to [Off].
No action required.
Enter the correct number of
digits for the WEP key.
Enter the correct number of
digits for the WEP key.
Turn the power off, and then
on. If the message appears
again, contact your sales or
service representative.
Turn the power off, and then
on. Remove and re-install the
HDD board correctly. If the
message appears again, con-
tact your sales or service rep-
resentative.
See "Attaching Hard Disk
Drive Type 4000", Setup
Guide.
84