Ricoh AP610N Software Manual page 73

Preparing for Printing
D:DRIVESRPCSWIN2K_XP(Language)DISK1
• PCL 5e
D:DRIVESPCL5EWIN2K_XP(Language)DISK1
• PCL 6
D:DRIVESPCL6WIN2K_XP(Language)DISK1
• PostScript 3
D:DRIVESPS3WIN2K_XP(Language)DISK1
When installation is complete, the printer connected to "1394_00n" appears
in the [Printers and Faxes] window. ("n" shows the number of printers connect-
ed.)
F
Follow the instructions.
❒ If the printer driver has already been installed, the printer icon is added to
the [Printers and Faxes] window. In this case, printer driver installation is not
necessary.
❒ Even if the printer driver is already installed, the message " Found New
Hardware Wizard" may appear when the printer and the computer are con-
nected using the IEEE 1394 interface cable for the first time. If it does, in-
stall the printer driver.
❒ If printing does not work properly after the installation, delete the port and
reinstall the printer driver. For details, see "Printer Does Not Print", Main-
tenance Guide.
❒ If you do not want to install the printer when Found New Hardware Wizard
starts under an operating system that supports SCSI print, disable the de-
vice by following the procedure below
A
When the [Found New Hardware Wizard] dialog box appears, check that
[This wizard helps you install software for: Unknown] displayed, select [Install
from a list on specific location (Advanced)] check box, and then click [Next >].
B
When the message "Please choose your search and installation option."
appears, clear all check boxes from [Search for the best driver in these loca-
tions.], and then click [Next >].
C When the message "The wizard could not find the software on your
computer for." appears, click [OK].
D When the message "Cannot Install this Hardware" appears, select the
[Don't prompt again to install the software] check box, and then click [Finish].
73